About Us
Products
Purchase
Downloads
Support
Forums
Contact Us
Site
 Register to post in forums, or Log in to your existing account
 

Play RetroMUD
Post new topic  Reply to topic     Home » Forums » zMUD General Discussion
malas
Newbie


Joined: 21 Jan 2004
Posts: 4

PostPosted: Sat Jan 24, 2004 7:58 pm   

problems with triggers
 
I have a database with creatures from the mud that are killable. I want to be able to scan the room, if the creature in the room is in the database then add the creature to a kill list. The script I wrote worked fine if there was only one creature in the room. However when there was more than one creature in the room, the triggered fired a second time while still processing the first on the list, which reset the counters, variables etc for the first one and promptly blows up any and all instances of the script running.

The pattern for the trigger is

&mobscan -- right here

but if there is something like

a beggar -- right here
a lady -- right here

it will start proccessing the beggar, get 1/2 done then start processing the lady and fall apart.

How would you set up a trigger so that it can either process one at a time if it fires multiple times quickly or that can match several times over a few lines and add the results to a stringlist before processing all of the items.[?]
Reply with quote
megamog75
Enchanter


Joined: 20 Nov 2002
Posts: 627
Location: USA

PostPosted: Sun Jan 25, 2004 2:07 am   
 
what you need first is a way to tell when your done with the first kill.
Like so:
a Begger is now dead.
or
the begger falls to the flore dead

You could use this to start the scan room process again

give example of the fight here all the way to the end and I am sure anyone here could help.
Reply with quote
LightBulb
MASTER


Joined: 28 Nov 2000
Posts: 4817
Location: USA

PostPosted: Sun Jan 25, 2004 5:38 pm   
 
Without details of what the trigger does, it's difficult to give any advice on it. Some possible approaches:
1. If the trigger contains looping structures, use #PRIORITY.
2. Give the trigger an ID and then use #T- as the first command in the trigger script. End the script with the #T+ command. This will disable the trigger during the time that it's processing.
3. Use the #ADDITEM command to add targets to a list and the #DELITEM or #DELNITEM command to remove them.
4. Set a variable to a predetermined value to indicate when you are fighting something. Check this variable with the #IF command before attacking.
Reply with quote
Display posts from previous:   
Post new topic   Reply to topic     Home » Forums » zMUD General Discussion All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

© 2009 Zugg Software. Hosted by Wolfpaw.net