Zugg Software :: View topic

Newbie Joined: 29 Nov 2021 Posts: 6

Hello
i have problem with speedwalking (fast mode) i have simply .10n and .10s aliases, when I have map off it goes normal, immediatly send 10s/10n to mud and everything works fine, when I have map on with fast speedwalk it does produce every single dir with about 0.5sdelay then after ~5s it sends all to MUD instead sending them immediately,
n
n
n
n
n
n
n
n
n
n
see something like that (just long 0.5s delay for each) and then i see output from moving (
when i have no map or safe/slow mode it send direction from alias normaly
whats going on?
BRs

Posted: Mon Nov 29, 2021 6:20 pm

In prefereces.
On the scripting tab on the left.
General Scripting tab on the top.

Do you have a value set for the delay between speedwalking steps?

Newbie Joined: 29 Nov 2021 Posts: 6

No, be default there was 0 for both, i was trying -1 or something, didnt help,
Windows 10, Cmud 3.34, it appears only when mapper is on, when I use the same alias without mapper it's sended to the mud normally... I tried changing many settings in mapper configuration with no result, i have it autoconfigured + fixed prompt configuration, and in map mode it works, makin rooms and exits correctly,
is it possible it depends on how big is map? need to check it but i think for example: when i use .10e its going faster when iam in small zone(small = less rooms) and it goes slower when in big zone (like 300roms or something

Newbie Joined: 29 Nov 2021 Posts: 6

ok found in different post thats all becouse of map zoomed out, when you zoom in to show less(much less) rooms at once its better, not perfect but better, its really silly and for me its bug, i have super fast computer and for sure its not about too low memory or processor power