Zugg Software :: View topic - [3.33a] Mapper not keeping up during speed walk

Newbie Joined: 31 Jan 2011 Posts: 1

There was another post similar that described my exact problem, but it didn't help me solve it. I was wondering if some people could check out Bedlam (bedlam.gotdns.com port 9000) and tell me what mapper config works.

Currently, I can auto-map just fine. However, when I try to speed walk in safe mode, I will end up in the correct place in game, but the mapper will only show me moving 1-2 rooms before it stops.

Fast mode, and slow mode works fine, but they're unsafe, or slow. =p

Also, on a related note, speed walking through doors has proven difficult since "open s" sometimes tries to open something in your inventory. Again I've read about some fixes for this, but the posts were old, and I couldn't get them to work, so I'm not sure if the info was outdated, or I was doing something wrong. Is there some way to change the "open" output to "open south" etc.

Thanks.

Posted: Mon Jan 31, 2011 6:49 am

I play a MUD from time to time where open s will try to open the first item with a keyword starting with s in my inventory, rather than the door. My solution was to make a copy of the English directions package that CMUD uses, rename it, then modify it so that instead of CMUD sending s when trying to move or open s, it will send south or open south. Then for that session I just changed it to load the revised package rather than the default one. Below is the XML for the revised package you can try if you want.