 |
Dumas
Enchanter
Joined: 11 Feb 2003
Posts: 511
Location: USA
|
 Posted: Mon Nov 22, 2004 4:08 pm
Inconsistent Mapper updating
|
I've had this problem for quite a while and want to finally try to get it out of the way.
I frequently add movement commands to exits(especially to cause swimming). Problem is that sometimes, even if I click the save button for the room properties and the command is there, the mapper doesn't update to use the command. IE, I put 'swim w' for the command. Typically, when I attempt to move to that room it will send 'swim w' to the mud. But it doesn't do it all the time and I am forced to go erase the command, save the room, then re-enter tha command again to get it to work right.
Any clue might be causing this? |
|
|
|
|
mr_kent
Enchanter
Joined: 10 Oct 2000
Posts: 698
|
Posted: Mon Nov 22, 2004 7:17 pm
|
I've noticed that in mapping mode, the alternative room-exit commands are not used in my map. Once I get things mapped and switch to follow mode, the commands such as 'swim w' work fine. This is a bit of a hassle for me when mapping large areas with alternative exit commands.
|
|
|
|
|
Dumas
Enchanter
Joined: 11 Feb 2003
Posts: 511
Location: USA
|
Posted: Tue Nov 23, 2004 1:30 am
|
Yeah, I know in mapping mode it doesn't do it. But my problem is that it doesn't do it in follow mode either.
|
|
|
|
|
|
|
|
