 |
nabob
Beginner
Joined: 01 Aug 2004
Posts: 10
|
 Posted: Thu Aug 05, 2004 10:28 pm
ASCII Import problems
|
I have experienced a lot of difficulty with import/ascii.
Sometimes it works just fine, and sometimes it works not at all.
I recently copy/pasted a class including several multi-state triggers put together by a friend. Everything looks fine in notepad, but when I import it.. the trigger patterns show up in the triggers with the braces included, not everything is imported, and generally, it is all messed up.
I went through and deleted all the blank lines between trigger definitions and still, Zmud choked on it.
Is there some kind of trick to getting Zmud to reliably import ascii scripts? |
|
|
|
|
LightBulb
MASTER
Joined: 28 Nov 2000
Posts: 4817
Location: USA
|
Posted: Fri Aug 06, 2004 2:50 am
|
No, there's no trick.
Or perhaps there is. Use default preferences and make sure your friend did too (especially special character assignments). |
|
_________________
LightBulb
Senior member
Most scripts in this forum are written for Command Line entry.
Don't even open the Settings Editor unless its use is specified or obvious. |
 |
|
|
|
|
|
