Zugg Software :: View topic

Novice Joined: 06 May 2008 Posts: 38

So, I went to edit a trig via the settings editor, but I got this error that said:

"Not enough storage is available to process this command."

I looked around, but none of the errors or solutions seemed relevant to my situation. Then, I noticed the place below where you can edit the trigger type, name, actions, ect wasn't there, as seen in this screenshot:
http://i50.tinypic.com/331oth3.jpg

Any suggestions?
I'm running zMUD 7.21 on Windows XP Pro SP3.

I don't think it's actually referring to the memory. I may only have 1gb of ram, but that shouldn't be a problem; I restarted my computer and ran TuneUp Utilities 2010 to clear all my cache ect. I also cleared my C:/Windows/Prefetch folder. So, I don't think it's a memory issue. Any ideas what could be wrong? If I can manage to get the error box to display again, I'll screenshot it and put the link in this post.

THanks.

GURU Joined: 23 Dec 2000 Posts: 4834 Location: USA

Dunno what caused it, but deleting setting.dok and possibly zmud.ini (if you have global settings, rename it instead) might fix it. Looks like the entire settings list is set to some insanely large width.