Register to post in forums, or Log in to your existing account
 

Play RetroMUD
Post new topic  Reply to topic     Home » Forums » zMUD General Discussion
Alok
Newbie


Joined: 14 Jun 2003
Posts: 7
Location: Namibia

PostPosted: Sun Jun 29, 2003 5:01 pm   

Gemstone automapping
 
I'm having a bit of trouble with the Auto Config on Gemstone (one of Simutronics's games). When I try and go into Map Creation mode (after doing the Auto Config), I get an error that says:

RoomRS: Cannot perform this operation on a closed dataset.

The error comes up every time output comes from the MUD, even something like someone entering the room. Since the MUD is kinda busy, I get this error multiplying quite a bit.

Here's what a typical room in this MUD looks like:

[Wehnimer's, Land's End Rd.]
Vigilant guardsmen scrutinize the citizens and travelers arriving and departing through the wide gateway spanning the land route into Wehnimer's Landing. The frenetic pace of the city to the south is a far cry from the deceptive calm of the wilds of Elanith outside. Two daunting towers survey the countryside and protect the town, flanking the road to the east and west. You also see a wooden barrel.
Obvious paths: south

The room title (In the []) is highlighted via Gemstone's GSL scripts already. When I configure, it highlights nothing.

~Alok
Reply with quote
Display posts from previous:   
Post new topic   Reply to topic     Home » Forums » zMUD General Discussion All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

© 2009 Zugg Software. Hosted by Wolfpaw.net